Administrator Guide

Layer 2 Switching Commands 707
Syntax
match ethertype {keyword | 0x0600-0xffff }
• keyword — Specifies either a valid keyword or a valid hexadecimal number.
The supported keywords are
appletalk , arp, ibmsna , ipv4, ipv6 , ipx ,
mplsmcast
, mplsucast , netbios , novell , pppoe , rarp . (Range:
0x0600–0xFFFF)
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add a match condition based on
ethertype.
console(config-classmap)#match ethertype arp
match ip6flowlbl
The match ip6flowlbl command adds to the specified class definition a
match condition based on the IPv6 flow label of a packet.
NOTE: This command is not available on the N1500 Series switches.
Syntax
match ip6flowlbl label
• label - The value to match in the Flow Label field of the IPv6 header
(Range 0-1048575).
Default Configuration
There is no default configuration for this command.
2CSNXXX_SWUM204.book Page 707 Monday, January 25, 2016 1:25 PM