Administrator Guide

Layer 2 Switching Commands 812
To detach the VLAN from this protocol-based group identified by this
groupid , use the no form of this command.
Syntax
protocol group group-id vlan-id
no protocol group group-id vlan-id
• group-id — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the
vlan
protocol group
command. To see the group ID associated with the name
of a protocol group, use the
show port protocol all command.
•
vlan-id — A valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
VLAN Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to attach the VLAN ID "100" to the
protocol-based VLAN group "3."
console(config-vlan)#protocol group 3 100
protocol vlan group
Use the protocol vlan group command in Interface Configuration mode to
add the physical unit/slot/port interface to the protocol-based group
identified by
groupid . A group may have more than one interface associated
with it. Each interface and protocol combination can be associated with one
group only. If adding an interface to a group causes any conflicts with
protocols currently associated with the group, this command fails and the
2CSNXXX_SWUM204.book Page 812 Monday, January 25, 2016 1:25 PM