Administrator Guide

Layer 2 Switching Commands 840
console(config-if-Gi1/0/1)#switchport trunk allowed vlan except
1,2,3,5,7,11,13
switchport trunk encapsulation dot1q
Use this command for compatibility. This command performs no action.
Syntax
switchport trunk encapsulation dot1q
Default Configuration
Dell Networking switches use dot1q encapsulation on trunk ports by default.
Command Mode
Interface config mode, Interface range mode (including port-channels)
User Guidelines
This command performs no action. Dell Networking switches always use
dot1q encapsulation on trunk mode ports.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example demonstrates compatibility.
console(config)#switchport trunk encapsulation dot1q
vlan
Use the vlan command in Global Configuration mode to configure a VLAN.
To delete a VLAN, use the no form of this command.
Syntax
vlan { vlan–id | vlan–range }
no vlan {
vlan–id | vlan–range }
• vlan–id —A valid VLAN ID. (Range: 1–4093)
2CSNXXX_SWUM204.book Page 840 Monday, January 25, 2016 1:25 PM