Administrator Guide

Layer 2 Switching Commands 844
vlan protocol group
Use the vlan protocol group command in Global Configuration mode to add
protocol-based groups to the system. When a protocol group is created, it is
assigned a unique group ID number. The group ID is used to identify the
group in subsequent commands. Use the no form of the command to remove
the specified VLAN protocol group name from the system.
Syntax
vlan protocol group group-id
no vlan protocol group group-id
• group-id — The protocol-based VLAN group ID, to create a protocol-
based VLAN group. To see the created protocol groups, use the
show port
protocol al
l command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)# vlan protocol group 1
vlan protocol group add protocol
Use the vlan protocol group add protocol command in Global Configuration
mode to add a protocol to the protocol-based VLAN groups identified by
groupid . A group may have more than one protocol associated with it. Each
interface and protocol combination can be associated with one group only. If
adding a protocol to a group causes any conflicts with interfaces currently
associated with the group, this command fails and the protocol is not added
to the group.
2CSNXXX_SWUM204.book Page 844 Monday, January 25, 2016 1:25 PM