Administrator Guide

Security Commands 878
Example
console(config-if-Gi1/0/1)# authentication priority mab dot1x captive-portal
console(config-if-Gi1/0/1)# no authentication priority
authentication restart
Use this command to set the interval after which reauthentication starts. This
timer starts only if all the authentication methods fail.
Use the no form of this command to set the authentication restart timer to
factory default value.
Syntax
authentication restart time
no authentication restart
• time —The time, in seconds, after which reauthentication starts, if all the
authentication methods have failed. Range: 300-65535.
Default Configuration
The default timer value is 300 seconds.
Command Modes
Interface VLAN Configuration mode
User Guidelines
None
Example
console(config-if-Gi1/0/1)# authentication timer restart 1800
console(config-if-Gi1/0/1)# no authentication timer restart
clear (IAS)
Use the clear aaa ias-users command in Privileged Exec mode to delete all
IAS users.
2CSNXXX_SWUM204.book Page 878 Monday, January 25, 2016 1:25 PM