Administrator Guide

Security Commands 914
User Guidelines
This command has no user guidelines.
security
Use the security command in Mail Server Configuration mode to set the e-
mail alerting security protocol. This enables and disables the switch to use
TLS authentication with the SMTP Server. If the administrator sets the TLS
mode and, if the SMTP sever does not support TLS mode, then no e-mail
goes to the SMTP server.
Syntax
security {tlsv1 | none}
Default Configuration
The default value is disabled.
Command Mode
Mail Server Configuration
User Guidelines
This command has no user guidelines.
mail-server ip-address | hostname
Use the mail-server ip-address | hostname command in Global
Configuration mode to configure the SMTP server IP address and change the
mode to Mail Server Configuration mode. The server address can be in the
IPv4, IPv6, or DNS name format. Use the no form of this command to
remove the configured SMTP server address.
Syntax
mail-server { ip-address | hostname }
no mail-server {
ip-address | hostname }
• ip-address —An IPv4 or IPv6 address.
2CSNXXX_SWUM204.book Page 914 Monday, January 25, 2016 1:25 PM