Administrator Guide

Security Commands 923
attribute 6
Use the attribute 6 command to configure the switch to send the RADIUS
Service-Type attribute in the Access-Request message sent to a specific
RADIUS authentication server.
Syntax
attribute 6 on-for-login-auth
no attribute 6 on-for-login-auth
Default Configuration
By default, the Service-Type is not included in the Access-Request message
sent to the authentication server.
Command Mode
RADIUS Server Configuration
User Guidelines
There are no user guidelines for this command.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#radius-server host 4.3.2.1
console(config-auth-radius)#attribute 6 on-for-login-auth
attribute 8
Use the attribute 8 command to configure the switch to send the RADIUS
Framed-IP-Address attribute in the Access-Request message sent to a specific
RADIUS authentication server. The switch sends the IP address of the host
attempting to authenticate in the Framed-IP-Address attribute in the Access-
Request sent to the authentication server.
2CSNXXX_SWUM204.book Page 923 Monday, January 25, 2016 1:25 PM