Administrator Guide

Security Commands 932
User Guidelines
There are no user guidelines for this command.
Example
console(Config-auth-radius)#msgauth
name (RADIUS server)
Use the name command to assign a name to a RADIUS server. Use the no
form of the command to return the name to the default (unspecified). The
no form of the command does not require the user to enter the configured
name.
Syntax
name servername
no name
• servername —The name for the RADIUS server (Range: 1 - 32 characters).
Default Configuration
The default RADIUS server name is Default-RADIUS-Server.
Command Mode
RADIUS Server Configuration mode
User Guidelines
Names may only be set for authentication servers, not for accounting servers.
Names may consist of alphanumeric characters and the underscore, dash and
blanks.Embed the name in double quotes to use a name with blanks.
Note that, when multiple RADIUS servers are configured with different
names (for example, ServerName is name1 and address is 1.1.1.1 and
ServerName is name2 and address is 1.1.1.2):
The RADIUS request is always sent to the first ordered name server list, i.e.
name1 server list would be tried before moving on to name2. Even if the
priority value of servers in name2 is lower (lower value indicates high priority)
2CSNXXX_SWUM204.book Page 932 Monday, January 25, 2016 1:25 PM