Administrator Guide

Security Commands 936
Syntax
radius-server attribute 6 on-for-login-auth
no radius-server attribute 6 on-for-login-auth
Default Configuration
By default, the switch does not send the service-type attribute to the
authentication server.
Command Mode
Global Configuration
User Guidelines
This command globally configures the switch to send the RADIUS Service-
Type attribute in the Access-Request message sent to all RADIUS
authentication servers. The switch sends the Service-Type value
Administrative (6) for administrators attempting to access the switch console
and sends Service-Type value Login (1) for users attempting to access the
network.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#radius-server attribute 6 on-for-login-auth
radius-server attribute 8
Use the radius-server attribute 8 command to enable the switch to send the
RADIUS Framed-IP-Address attribute in authentication messages sent to the
authentication server.
Syntax
radius-server attribute 8 include-in-access-req
no rradius-server attribute 8 include-in-access-req
2CSNXXX_SWUM204.book Page 936 Monday, January 25, 2016 1:25 PM