Administrator Guide

Security Commands 985
Syntax
ignore {session-key | server-key}
no ignore {session-key | server-key}
• Session-key—Do not attempt to authenticate with the session key.
• Server-key—Do not attempt to authenticate with the server key.
Default Configuration
The default is to authenticate using the parameters as specified by the
configured auth-type.
Command Modes
Dynamic Radius Configuration
User Guidelines
This command specifies the attributes to validate before acting on a CoA or
disconnect request. If session-key is specified and the session ID is valid,
authentication succeeds even if the session-key does not match.
This command works in concert with the ignore command. The ignore
command refines the all parameter to limit the attribute matching.
Setting the auth-type to session-key in conjunction with setting the ignore
session-key is invalid and causes all configured servers to authenticate with no
warnings.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-radius-da)# ignore session-key
port
Use this command to set the port on which to listen for CoA and disconnect
requests from authorized dynamic RADIUS clients.
2CSNXXX_SWUM204.book Page 985 Monday, January 25, 2016 1:25 PM