Administrator Guide
Layer 3 Routing Commands 1347
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration sub-
modes
User Guidelines
The following fields are displayed.
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console(config)#show bgp ipv6 community
Field Description
BGP table version Each time phase 2 of the BGP decision process runs to
select new BGP routes, this number is incremented.
Status codes
• s—The route is aggregated into an aggregate address
configured with the summary-only option
• *—Dell EMC Networking BGP never displays invalid
routes; so this code is always displayed (to maintain
consistency with the industry standard)
• >—Indicates that BGP has selected this path as the
best path to the destination
•
i—If the route is learned from an internal peer
Network IPv6 Destination prefix
Next Hop The route’s BGP next hop
Metric Multi-Exit Discriminator
LocPrf The local preference
Path The AS path