Administrator Guide

Layer 3 Routing Commands 1358
show bgp ipv6 neighbors policy
Use this command to display the inbound and outbound IPv6 policies
configured for a specific peer. The output distinguishes policies that are
configured on the peer itself and policies that the peer inherits from a peer
template. This command deprecates and replaces the show ipv6 bgp
neighbors policy command.
Syntax
show bgp ipv6 neighbors [ ipv4-address | ipv6-address [ interface interface-id
] ] policy
• ipv4-address—The IPv4 address of a neighbor may optionally be specified
to limit the output to a single neighbor.
• ipv6-address [ interface interface-id ]—The IPv6 address of a neighbor. If
specified, the output shows only this neighbor. If the neighbor’s address is
a link local address, the interface must be specified.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration sub-
modes
User Guidelines
The following fields are displayed.
Command History
Introduced in version 6.2.0.1 firmware.
Field Description
Neighbor The peer address of a neighbor.
Policy A neighbor-specific BGP policy.
Template If the policy is inherited from a peer template, this field
lists the template name.