Administrator Guide

Switch Management Commands 1999
Default Configuration
By default, IPv6 is not enabled on the out-of-band port.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
This command is not necessary if an IPv6 address has been assigned to the
interface. This command is only valid for switches equipped with an out-of-
band interface.
ipv6 gateway (OOB Configuration)
Use the ipv6 gateway command in Interface (out-of-band) Configuration
mode to configure the address of the IPv6 gateway. The gateway is used as a
default route for packets addressed to network devices not present on the
local subnet. Use the no form of the command to remove the gateway
configuration.
Syntax
ipv6 gateway ipv6-address
no ipv6 gateway
• ipv6-address—An IPv6 address (not a prefix).
Default Configuration
By default, no IPv6 gateway is configured.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
This command is only valid for switches equipped with an out-of-band
interface.