Administrator Guide

Switch Management Commands 2174

Command Mode

Global Configuration mode

User Guidelines

A signed X509 certificate must be present on the switch in order for DTLS

(logging protocol 1) to operate. See the crypto commands for further

information on certificates.

Up to eight syslog servers can be configured.

The Dell EMC Networking uses the local7(23) facility in the syslog message

by default. Syslog messages will not exceed 96 bytes in length. Syslog protocol

version 0 messages use the following format:

PRI This consists of the facility code (see RFC 3164) multiplied by

8 and added to the severity. See below for more information on

severity.

Timestamp The system up time. For systems that use SNTP, this is UTC.

When time zones are enabled, local time will be used.

Host IP Address or

Host Name

The IP address or Host Name of the local system.

<190> Jan 01 00:00:06 0.0.0.0-1 General[fp_main_task]: bootos.c(191) 4 %% INFO Event(0xaaaaaaaa)

| | | | | | | | | | |

| | | | | | | | |

| | | | | | | |

| | | | | | |

| | | | | |

| | | | |

| | | | Component Name

| | | |

| | | Stack Member

| | |

| | Host IP address or Host Name

| Timestamp

PRI