Users Guide

Layer 3 Routing Commands 1445
• address-family
• allowas-in
• connect-retry-interval
• description
• ebgp-multihop
• fall-over
• local-as
• password
• remote-as
• rfc5549-support
• shutdown
• timers
• update-source
See the associated neighbor commands for a description of parameters and
keywords. Note that Dell EMC Networking does not support a remote-as
as-
number
command in this mode. The neighbor’s AS number must be
specified when the neighbor is created.
Command History
Introduced in version 6.2.0.1 firmware. Additional command options added
in 6.3.0.1 firmware.
Example
console(config)# router bgp 65000
console(config-router)# neighbor 172.20.1.2 remote-as 65001
console(config-router)# neighbor 172.20.2.2 remote-as 65001
console(config-router)# template peer AGGR
console(config-rtr-tmplt)# timers 3 9
console(config-rtr-tmplt)# address-family ipv4
console(config-rtr-tmplt-af)# send-community
console(config-rtr-tmplt-af)# route-map RM4-IN in
console(config-rtr-tmplt-af)# route-map RM4-OUT out
console(config-rtr-tmplt-af)# exit
console(config-rtr-tmplt)# address-family ipv6
console(config-rtr-tmplt-af)# send-community
console(config-rtr-tmplt-af)# route-map RM6-IN in
console(config-rtr-tmplt-af)# route-map RM6-OUT out
console(config-rtr-tmplt-af)# exit