Users Guide

Table Of Contents
Layer 3 Routing Commands 1637
Example
console(config-if-vlan10)#show ipv6 snooping counters
IPv6 Dropped Messages
RA (Router Advertisement – ICMP type 134),
REDIR (Router Redirect – ICMP type 137)
Interface RA REDIR
--------------- ---------- ----------
Gi1/0/1 0 0
Gi1/0/2 431 6599
show ipv6 traffic
Use the show ipv6 traffic command in User Exec mode to show traffic and
statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [vlan
vlan-id
| tunnel
tunnel-id
| loopback
loopback-id
]
vlan-id
— Valid VLAN ID, shows information about traffic on a specific
interface or, without the optional parameter, shows information about
traffic on all interfaces.
tunnel-id
— Tunnel identifier. (Range: 0-7)
loopback-id
— Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
User Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Examples
The following examples show traffic and statistics for IPv6 and ICMPv6, first
for all interfaces and an individual VLAN.