Users Guide

Layer 3 Routing Commands 1678
• hash-mask-len —The length of a mask that is to be ANDed with the group
address before the hash function is called. All groups with the same seed
hash correspond to the same RP. For example, if this value is 24, only the
first 24 bits of the group addresses matter. This allows you to get one RP
for multiple groups. (Range 0–128 bits).
•
priority —The priority of the candidate BSR. The BSR with the higher
priority is preferred. If the priority values are the same, the router with the
higher IP address is the BSR. (Range: 0–255).
• interval—The interval at which candidate rendezvous point
advertisements are sent.
Default Configuration
The router will not announce its candidacy by default.
The default hash mask length is 126 bits.
The default priority is 0.
The default C-RP advertisement interval is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim bsr-candidate vlan 9 10 34
ipv6 pim dense-mode
Use the ipv6 pim dense-mode command in Global configuration mode to
administratively configure PIM dense mode for IPv6 multicast routing. This
command also enables MLD. Use the no form of this command to disable
PIM and MLD. This command does not affect ip multicast-routing.
Syntax
ipv6 pim dense-mode