Users Guide

Layer 3 Routing Commands 1945
User Guidelines
Once interface tracking is enabled, the VRRPv3 feature receives notifications
when an interface changes state. The decrement option decreases the priority
of the switch within a VRRPv3 group by the specified value when an interface
goes down.
Command History
Command introduced in version 6.6 firmware.
Example
The following example shows how to set IP address of the device within a
Virtual Router Redundancy Protocol (VRRPv3) group:
console(config-if-vrrp)#track ip route 2001::1/64 secondary
clear vrrp statistics
Use this command to clear VRRP statistical information for given interface of
the device within a Virtual Router Redundancy Protocol version 3 (VRRPv3)
group and IP address family.
Syntax
clear vrrp statistics [{ ipv4 | ipv6 } vlan vlan-id vr-id ]
•
ipv4 —(Optional) Indicates the Virtual router group belongs to an IPv4
address family.
•
ipv6 —(Optional) Indicates the Virtual router group belongs to an IPv6
address family.
• vlan
vlan-id —(Optional) Indicates the VLAN number to which the Virtual
router belongs.
•
vr-id —(Optional) Virtual router group number. The range is from 1 to 255.
Default Configuration
Tracking is not enabled by default.
Command Mode
Privileged Exec mode