Users Guide

Using the CLI 250
• Policy Class — Use the class command to access the QoS Policy-class
mode to attach or remove a diffserv class from a policy and to configure
the QoS policy class.
• Class-Map — This mode consists of class creation/deletion and matching
commands. The class matching commands specify layer 2, layer 3 and
general match criteria. Use the class-map class-map-name commands to
access the QoS Class Map Configuration mode to configure QoS class
maps.
• Stack — Use the stack command to access the Stack Configuration Mode.
• SSH Public Key-chain — Contains commands to manually specify other
switch SSH public keys. The Global Configuration mode command crypto
key pub-key chain ssh is used to enter the SSH Public Key-chain
configuration mode.
• SSH Public Key-string — Contains commands to manually specify the
SSH Public-key of a remote SSH Client.
• MAC Access-List — Configures conditions required to allow traffic based
on MAC addresses. The Global Configuration mode command mac
access-list is used to enter the MAC Access-List configuration mode.
• TACACS — Configures the parameters for the TACACS server.
• RADIUS — Configures the parameters for the RADIUS server.
• SNMP Host Configuration — Configures the parameters for the SNMP
server host. Only IPv4 hosts are supported.
• Crypto Certificate Request — Configures the parameters for crypto
certificate request.
• Crypto Certificate Generation — Configures the parameters for crypto
certificate generate.
• Logging — Configures the parameters for SYSLOG servers.
• VLAN— Creates a VLAN and configures non-L3 parameters on a VLAN.
• Virtual Router Configuration— Configures parameters for a virtual
routing instance.
Pre-configuration
Nearly all switch features support a pre-configuration capability, even when a
feature is not enabled or the required hardware is not present.