Users Guide

Security Commands 954
If the switch discovers that the host has obtained an IPv4/IPv6 address, it may
send the Acct-Start packet before the expiry of the delay period.
The delay is accounted for in the Acct-Delay-Time attribute sent to the
RADIUS accounting server.
Use the show authentication clients command to display the discovered IPv4
address/IPv6 address received from RADIUS server, if any.
Command History
Command introduced in firmware release 6.5.2.
aaa accounting update
Use the aaa accounting update command to enable the sending of interim
accounting packets to RADIUS accounting server(s).
Syntax
aaa accounting update {[newinfo][periodic minutes ]}
no aaa accounting update
• periodic minutes—The number of minutes to wait before sending the
Interim-Update packet to the RADIUS accounting server. The range for
minutes is from 1 to 10081.
• newinfo—Send the Interim-Update packet to the RADIUS accounting
server whenever new information is available.
Default Configuration
By default, the sending of Interim-Update packets is disabled. There is no
default time period.
Command Mode
Global Configuration mode
User Guidelines
User of the newinfo keyword can cause congestion if many accounted sessions
are present on the switch.