Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch N2100 Series
1331133213331334133513361337133813391340
Table Of Contents
1332 OSPF and OSPFv3
8
Configure the loopback interface. The switch uses the loopback IP address
as the OSPF and OSPFv3 router ID.
console(config)#interface loopback 0
console(config-if-loopback0)#ip address 2.2.2.2 255.255.255.0
console(config-if-loopback0)#exit
console(config)#exit
Configuring the Static Area Range Cost
Figure 34-39 shows a topology for the configuration that follows.
Figure 34-39. Static Area Range Cost Example Topology
1
Configure R0.
terminal length 0
config
hostname ABR-R0
line console
exec-timeout 0
exit
vlan 101-103
exit
ip routing
router ospf
router-id 10.10.10.10