Users Guide

OSPF and OSPFv3 1343
console(config-if-vlan100)#ip address 192.168.0.1 /24
Put the VLAN interface into the VRF:
console(config-if-vlan100)#ip vrf forwarding red
console(config-if-vlan100)#exit
Routing interface moved from Default router instance to red router
instance.
Enable OSPF on the VRF, assign a network and enable OSPF for the VRF:
console(config)#router ospf vrf red
console(Config-router-vrf-red)#network 192.168.0.0 0.0.0.255 area 0
console(Config-router-vrf-red)#router-id 192.168.0.253
console(Config-router-vrf-red)#redistribute connected
console(Config-router-vrf-red)#enable
console(Config-router-vrf-red)#exit
console(config)#show ip ospf vrf red
Router ID...................................... 192.168.0.253
OSPF Admin Mode................................ Enable
RFC 1583 Compatibility......................... Enable
External LSDB Limit............................ No Limit
Exit Overflow Interval......................... 0
Spf Delay Time................................. 5 seconds
Spf Hold Time.................................. 10 seconds
Flood Pacing Interval.......................... 33 ms
LSA Refresh Group Pacing Time.................. 60 seconds
Opaque capability.............................. Enable
AutoCost Ref BW................................ 100 Mbps
Default Passive Setting........................ Disabled
Maximum Paths.................................. 16
Default Metric................................. Not configured
Stub Router Configuration...................... None
Summary LSA Metric Override.................... Disabled
Default Route Advertise........................ Disabled
Always......................................... False
Metric......................................... Not configured
Metric Type.................................... External Type 2