Users Guide

Layer 3 Routing Commands 1244
Command Mode
Peer Template Configuration mode
User Guidelines
This command enters address family configuration mode within the peer
template. Policy commands configured within this mode apply to the address
family. The following commands can be added to a peer template in address
family configuration mode:
• activate
• advertisement-interval seconds
• default-originate
• filter-list as-path-list-number {in | out}
• maximum-prefix { maximum | unlimited } [threshold]
• next-hop-self
• prefix-list prefix-list-name { in | out }
• remove-private-as
• route-reflector-client
• route-map map-name { in | out }
• send-community
The activate command is only available in address-family ipv6 mode.
If an IPv6 peer inherits a template that specifies address family ipv4
parameters, those parameters are ignored.
Command History
Introduced in version 6.2.0.1 firmware.
Example
In this example, the peer template AGGR sets the keepalive timer to 3
seconds and the hold timer to 9 seconds, allows communities to be sent for
both IPv4 and IPv6 routes, and configures different inbound and outbound
route maps for IPv4 and IPv6. Two neighbors, 172.20.1.2 and 172.20.2.2,
inherit these parameters from the template.
console(config)# router bgp 65000