Users Guide
Layer 3 Routing Commands 1886
Syntax
vrrp group-id address-family {ipv4 | ipv6}
no vrrp group-id address-family {ipv4 | ipv6}
• group-id—Virtual router group number. The range is from 1 to 255.
•
address-family
—Specifies the address-family for this VRRP group.
•
ipv4
—(Optional) Specifies IPv4 address.
•
ipv6
—(Optional) Specifies IPv6 address.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
To use the no vrrp group-id address-family {ipv4 | ipv6} command, disable
the virtual router with the shutdown command in the corresponding VRRP
config mode.
VRRPv2 and VRRPv3 are not compatible. Do not use both VRRPv2 and
VRRPv3 together in a network.
Command History
Command introduced in version 6.6 firmware.
show vrrp
This commands displays information about the status and configuration
details for a given Virtual Router Redundancy Protocol version 3 (VRRPv3)
group configured on the specified interface for a specified IP address family.
Syntax
show vrrp {ipv4 | ipv6} [ vlan vlan-id vr-id ]
•
ipv4
—(Optional) Indicates the Virtual router group belongs to the IPv4
address family.