Users Guide

Switch Management Commands 1906
boot auto-copy-sw
Use the boot auto-copy-sw command to enable or disable Stack Firmware
Synchronization.
Use the no form of the command to disable Stack Firmware Synchronization.
Syntax
boot auto-copy-sw
no boot auto-copy-sw
Default Configuration
Stack firmware synchronization is disabled by default.
Command Mode
Global Config
User Guidelines
The configuration on the master switch controls the stack as if it is a single
switch. No configuration steps need to be taken on the member switches to
synchronize the firmware.
boot auto-copy-sw allow-downgrade
Use the boot auto-copy-sw allow-downgrade command to enable automatic
downgrade of the firmware version on a stack member if the firmware version
on the manager is older than the identified firmware version.
Use the no form of the command to disable downgrading the image.
Syntax
boot auto-copy-sw allow-downgrade
no boot auto-copy-sw allow-downgrade
Default Configuration
The default value is enabled.