Users Guide

Switch Management Commands 1909
User Guidelines
A configuration file (CLI commands) may be downloaded during the Auto-
Install process via DHCP configuration or via UCSB configuration. Refer to
the DHCP and USB Auto-Configuration topic in the User’s Configuration
Guide for more information.
Example
console#
console#configure
console(config)#boot host auto-save
console(config)#no boot host auto-save
boot host dhcp
Use the boot host dhcp command in Global Configuration mode to enable
Auto-Install and Auto Configuration on the switch. When a switch boots
with a saved startup configuration that includes this command, the Auto-
Install process is triggered. Use the no form of this command to disable Auto-
Install on the next reboot if the reboot occurs with a saved startup
configuration. If you give this command while the Auto-Install process is
running, the Auto-Install process terminates. The Auto-Install process has an
internal timer that retries failed installations for ten minutes.
Syntax
boot host dhcp
no boot host dhcp
Default Configuration
The default value is Enabled.
Command Mode
Global Configuration.
User Guidelines
This command has no user guidelines