Users Guide

Switch Management Commands 2177
Example
The following example displays the SNMP communications status.
console(config)#show snmp
Community-String Community-Access View Name IP Address IP
Mask
-------------------- ---------------- ---------------- ----------- --------
private Read/Write Default All All
public Read Only Default 1.1.1.1 255.255.255.254
Community-String Group Name IP Address IP Mask
-------------------- ------------------------------ ---------- -------------
private DefaultWrite All All
public DefaultRead All All
Traps are enabled.
Authentication trap is enabled.
Version 1,2 notifications
Target Address Type Community Version UDP Filter TO
Retries
Port name Sec
---------------- ------- -------------------- ------- ------ -------- --- --
----
Version 3 notifications
Target Address Type Username Security UDP Filter TO
Retries
Level Port name Sec
---------------- ------- ------------------ -------- ------ -------- --- ---
----
System Contact:
System Location:
Source Interface:
SNMP trap Client Source Interface.............. Default
show snmp engineid
Use the show snmp engineid command to display the ID of the local Simple
Network Management Protocol (SNMP) engine.