Users Guide

Switch Management Commands 2327
The use of 10G stacking links on the N3200-ON is not recommended when
100G uplinks are utilized. If packet loss on the stacking links or stack splits are
encountered in this configuration, the stacking links must be upgraded to at
least 50G.
Command History
Added the speed parameter in version 6.5. Syntax updated in firmware release
6.6.1. The 100g/10g syntax was added in firmware release 6.6.2.
Example
console(config-stack)#stack-port tengigabitethernet 1/0/3 stack
stack-port shutdown
Use this command to enable or disable the stack port administratively. This
command is usually used to diagnose the stack in case any one of the stack
ports is exhibiting errors.
Syntax
stack-port interface-id shutdown
no stack-port interface-id shutdown
• interface-id—The stacking interface identifier.
Default Configuration
There no default configuration for this command.
Command Modes
Stack Configuration mode
User Guidelines
This command must be used with caution, as disabling a stack port causes
the stack to attempt to reconverge. Ensure that the stack is in an active ring
topology in order to avoid a stack split. Check the stack ports for errors and
also verify that NSF is synced before shutting down any stacking links.
Application messages will appear in the logs during stack convergence.