Users Guide

Layer 2 Switching Commands 458
a defect still exists on the trail that started the timer. If it does, that defect
will be reported to protection switching. Range: 0 to 10000 ms in
increments of 100 ms, for example, a value of 500 implies 500
milliseconds.
• wait-to-restore timer—When a fault condition is cleared, the traffic
channel reverts after the expiry of a WTR timer (if no fault condition is
present). This timer is used to avoid toggling protection states in case of
intermittent defects. Range: 1 to 12 minutes.
Default Configuration
The defaults are:
• guard timer: 500 ms
• hold-off timer: 0 ms
• wait-to-restore timer: 5 minutes
Command Mode
Ethernet Ring Profile Configuration mode
User Guidelines
See parameter descriptions above.
Example
This example sets the hold-off timer to 500 milliseconds for profile1.
console (config)# ethernet ring g8032 profile profile1
console (config-erp-profile1)#timer hold-off 500
Command History
Command introduced in firmware release 6.6.1.
non-revertive
This command enables non-revertive mode for an Ethernet ring profile. Use
the no form of the command to reset the profile to revertive mode.