Users Guide

Layer 2 Switching Commands 491
Use the no form of the command to return the configuration to the default.
Syntax
green-mode eee tx-idle-time <600-4294967295>
green-mode eee tx-wake-time <0-65535>
no green-mode eee {tx-idle-time|tx-wake-time}
Default Configuration
By default, the transmit idle time is 600 micro-seconds and the transmit wake
time is 8 micro-seconds.
Command Mode
Interface Configuration mode, Interface Range Configuration mode
User Guidelines
The tx-idle-time parameter sets the amount of time the link must be idle
before transitioning to the low power idle state. The tx-wake-time configures
the delay before transitioning to the active state (and transmitting the
pending packet) after transmitting a wake symbol to the link partner. The
transmit idle time and transmit wake time are configured in micro-seconds.
The default values are recommended unless there is good reason to adjust
them. Excessive wake times may cause link congestion. Excessive idle times
will reduce the savings from low power idle mode.
This command is available in Ethernet interface configuration mode for
copper ports that are EEE capable. Configuring the values on interfaces that
do not support EEE will return an error.
Command History
Syntax added in 6.4 release.
clear green-mode statistics
Use the clear green-mode statistics command to clear:
• The EEE LPI event count, and LPI duration