Users Guide

Layer 2 Switching Commands 648
show vpc peer-keepalive
Use the show vpc peer-keepalive command to display the peer MLAG
switch’s IP address used by the Dual Control Plane Detection Protocol. The
port used for the Dual Control Plane Detection Protocol is shown, as well as if
peer detection is enabled or not. If enabled, the detection status is displayed.
Syntax
show vpc peer-keepalive
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged Exec mode and above
User Guidelines
A VPC domain ID must be configured for this command to display the
keepalive status.
Example
(Switching) # show vpc peer-keepalive
Peer IP address............................10.130.14.55
Source IP address..........................10.130.14.54
UDP port...................................50000
Peer detection admin status................Enabled
Peer detection operational status..........Up
Peer is detected...........................True
Configured Tx interval.....................500 milliseconds
Configured Rx timeout......................2000 milliseconds
Operational Tx interval....................500 milliseconds
Operational Rx timeout.....................2000 milliseconds
show vpc role
Use the show vpc role command to display information about the keepalive
status and parameters. The role of the MLAG switch as well as the system
MAC and priority are displayed.