Setup Guide

inet addr:x.x.x.x Bcast:x.x.x.x Mask:x.x.x.x

inet6 addr: fe80::92b1:1cff:fef4:9c76/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:18 errors:0 dropped:0 overruns:0 frame:0

TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000

RX bytes:1152 (1.1 KiB) TX bytes:6864 (6.7 KiB)

Interrupt:21 Memory:ff300000-ff320000

To assign an IP address to the management interface, eth0, and verify network connectivity, use the ifconfig eth0 <ip

address> command, as shown:

ONIE:/ # ifconfig eth0 x.x.x.x netmask x.x.x.x UP

Then set speed on management interface as below

ONIE:/ # ethtool -s eth0 speed 100 duplex full

Verify the network connection with ping.

ONIE:/ # ping x.x.x.x

PING x.x.x.x (x.x.x.x): 56 data bytes

64 bytes from x.x.x.x: seq=0 ttl=62 time=1.357 ms

64 bytes from x.x.x.x: seq=1 ttl=62 time=0.577 ms

10 ONIE installation instructions