Setup Guide

[ 18.707185] sd 6:0:0:0: Attached scsi generic sg1 type 0

[ 18.707703] sd 6:0:0:0: [sdb] 15148608 512-byte logical blocks: (7.75 GB/7.22 GiB)

[ 18.796392] sd 6:0:0:0: [sdb] Write Protect is off

[ 18.797033] sd 6:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support

DPO or FUA

[ 19.159563] sd 6:0:0:0: [sdb] Attached SCSI removable disk

up.

Info: Trying DHCPv4 on interface: eth0

ONIE: Using DHCPv4 addr: eth0: 1[ 20.053045] random: dropbearkey urandom read with 94 bits

of entropy available

x.xx.xxx.xx / xxx.xxx.xxx.x

Starting: dropbear ssh daemon... done.

Starting: telnetd... done.

discover: ONIE embed mode detected. Running updater.

Starting: discover... done.

Please press Enter to activate this console. Info: eth0: Checking link... up.

Info: Trying DHCPv4 on interface: eth0

ONIE: Using DHCPv4 addr: eth0: x.xx.xxx.xx / xxx.xxx.xxx.x

ONIE: Starting ONIE Service Discovery

Info: Found static url: file:///lib/onie/onie-updater

[ 29.744855] random: nonblocking pool is initialized

ONIE: Executing installer: file:///lib/onie/onie-updater

Verifying image checksum ... OK.

Preparing image archive ... OK.

ONIE: Version : x.xx.x.x

ONIE: Architecture : x86_64

ONIE: Machine : dell_<platform>_c2538

ONIE: Machine Rev : 0

ONIE: Config Version: 1

Installing ONIE on: /dev/sda

/proc/devices: No entry for device-mapper found

ONIE: Success: Firmware update URL: file:///lib/onie/onie-updater

ONIE: Success: Firmware update version: x.xx.x.x

ONIE: Rebooting...

discover: ONIE embed mode detected.

Stopping: discover...start-stop-daemon: warning: killing process 1441: No such process

Stopping: dropbear ssh daemon... done.

Stopping: telnetd... done.

Stopping: syslogd... done.

Info: Unmounting kernel filesystems

The system is going down NOW!

Sent SIGTERM to all processes

Sent SIGKILL to all processes

Requesting system reboot

After the Embed-ONIE installation completes, the system bootups and presents the ONIE menu.

Figure 3. ONIE install menu

N2200-ON and N3200-ON Series instructions