Users Guide

Security Commands 1076
Command History
Syntax added in version 6.6 firmware.
Example
The following example globally configures an interface to allow a single host
to authenticate.
console(config)# authentication host-mode single-host
authentication max-users
Use the authentication max-users command in Interface Configuration
mode to set the maximum number of clients supported on the port when
multi-auth host mode is enabled on the port. Use the no version of the
command to reset the maximum number of clients supported on the port to
the default.
Syntax
authentication max-users users
no authentication max-users
• users — The number of users the port supports for multi-auth
authentication (Range: 1–64)
Default Configuration
By default, the maximum number of clients supported by the switch are
allowed to authenticate on a port. For the N1100-ON and N1500 Series
switches, the range is 1–32.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The maximum number of clients that can authenticate on a port is 64. For
the N1100-ON and N1500 Series switches, the maximum number of clients is
to 32.