Users Guide

Layer 3 Routing Commands 1347
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console# show bgp ipv6
BGP table version is 5, local router ID is 20.1.1.1
Status codes: s suppressed, * valid, > best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Path
*> 2001:DB8::/48 3FFE:100::1 10 100 20 10 i
3FFE:200::4
*> 2001:DB8:4:5::/64 3FFE:100::1 10 100 20 10 ?
show bgp ipv6 aggregate-address
Use this command to display the configured IPv6 aggregate addresses and
indicates if each address is currently active. This command replaces and
deprecates the show ipv6 bgp aggregate-address command.
Status codes • s—The route is aggregated into an aggregate address
configured with the summary-only option
• *—Dell EMC Networking BGP never displays invalid
routes; so this code is always displayed (to maintain
consistency with the industry standard)
• >—Indicates that BGP has selected this path as the
best path to the destination
•
i—If the route is learned from an internal peer
Network IPv6 Destination prefix
Next Hop The route’s BGP next hop
Metric Multi-Exit Discriminator
LocPrf The local preference
Path The AS path
Origin The value of the Origin attribute