Users Guide

Layer 3 Routing Commands 1393
Default Configuration
By default, information about the global VRF is shown.
Command Mode
User Exec mode, Privileged Exec mode, Global Config mode and all sub-
modes.
User Guidelines
If the vrf-name argument is specified, information pertaining to that VRF is
displayed.
The following information is displayed.
Fields Description
Delta T How long since the decision process was run.
hours:minutes:seconds if the elapsed time is less than 24
hours. Otherwise, days:hours.
Phase The phase of the decision process that was run.
Upd Grp Outbound update group ID. Only applies when phase 3
is run.
GenId Generation ID of BGP routing table when decision
process was run. The generation ID is incremented each
time phase 2 of the decision process is run and when
there is a change to the status of aggregate addresses.
Reason The event that triggered the decision process to run.
Peer Phase 1 of the decision process can be triggered for a
specific peer when a peer’s inbound routing policy
changes or the peer is reset. When phase 1 is run for a
single peer, the peer’s IP address is given.
Duration How long the decision process took, in milliseconds.
Adds The number of routes added. For phase 1, this is the
number of prefixes that pass inbound policy and are
added to the Accept-RIB-In. For phase 2, this is the
number of routes added to the BGP routing table. For
phase 3, this is the number of prefixes added to the
update group’s Adj-RIB-Out.