Users Guide

Layer 3 Routing Commands 1872
Default Configuration
No description is present.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command accepts any printable characters for the name other than a
question mark. Descriptions containing spaces must be enclosed in quotes.
Example
The following example creates virtual router group 5 on VLAN 15 and
configures its description.
console(config)#interface vlan 15
console(config-if-vlan15)#vrrp 5
console(config-if-vlan15)#vrrp 5 description “Sales and Marketing”
vrrp ip
Use the vrrp ip command in Interface Configuration mode to enable VRRP
and set the virtual router IP address value for an interface. Use the no form of
the command remove the secondary IP address. It is not possible to remove
the primary IP address once assigned. Remove the VRRP group instead.
Syntax
vrrp group ip ip-address [secondary]
no vrrp group ip ip-address vlan secondary
• group—The virtual router identifier. (Range: 1-255)
• ip-address—The IP address of the virtual router.
• secondary—Designates the virtual router IP address as a secondary IP
address on an interface.
Default Configuration
VRRP is not configured on the interface.