Users Guide

Switch Management Commands 2150
• password – the user id configured on the FTP server requires a password.
• password—The password associated with the user id on the FTP server.
• ip address—The IPv4 address of an FTP or TFTP server.
• usb — Store the core dump on a USB device. A USB device must be
inserted into the switch front panel.
• none — Core dumps are disabled.
Stack-ip-address parameters:
• ipv4-address—The address used by the of the out-of-band port of the
switch during crash dump transfer.
• netmask —The netmask for use with the ip address for core dump
transfer.
• gateway —The default gateway to use on the out-of-band port for core
dump transfer.
• protocol dhcp—Obtain the out-of-band port address via DHCP for core
dump transfer.
• protocol static—Use a statically assigned address for core dump transfer.
Default Configuration
Debug core dumps are disabled by default.
The out-of-band port attempts to retrieve an IP address via DHCP by default.
No TFTP or FTP server is defined.
No stack IP addresses are assigned
Compression is enabled by default
Command Modes
Global Configuration mode
User Guidelines
Crash dump retrieval via FTP or TFTP occurs after the system has crashed.
During this time, the switch is not available for normal operation.
If no DHCP server is available for assignment of addresses to switches, the
exception dump stack-ip-address protocol static add command should be
used once for each member of the stack. It is recommended that these