Users Guide

Switch Management Commands 2194
User Guidelines
An SNMP server filter identifies the objects to be included or excluded from
notifications sent to a server per RFC 2573 Section 6 "NotificationFiltering."
This command can be entered multiple times for the same filter record. Later
lines take precedence when an object identifier is included in two or more
lines.
The filter name may include any printable characters except a question mark.
Enclose the string in double quotes to include spaces within the name. The
surrounding quotes are not used as part of the name. The CLI does not filter
illegal characters and may accept entries up to the first illegal character or
reject the entry entirely. Per RFC 2573, configuring a filter adds an implicit
exclude-all as the first entry in a filter record. Unless an include statement is
specified, all notifications are excluded by default.
Examples
The following example creates a filter that includes all objects in the MIB-II
system group except for sysServices (System 7) and all objects for interface 1
in the MIB-II interfaces group.
console(config)# snmp-server filter user-filter system included
console(config)# snmp-server filter user-filter system.7 excluded
console(config)# snmp-server filter user-filter ifEntry.*.1 included
snmp-server group
Use the snmp-server group command in Global Configuration mode to
configure a new Simple Management Protocol (SNMP) group or a table that
maps SNMP users to SNMP views. To remove a specified SNMP group, use
the no form of this command.
Syntax
snmp-server group groupname { v1 | v2 | v3 { noauth | auth | priv } [
notify notifyview ] } [ context contextname ] [ read readview ] [ write
writeview ]
no snmp-server group groupname { v1 | v2 | v3 { noauth | auth | priv } } [
context contextname ]
• groupname — Specifies the name of the group. (Range: 1-30
characters.)