Users Guide

Using the CLI 235
Table 2-4. Interface Identifiers
A single character short form of the interface commands indicated in
Table 2-4 is implemented in version 6.5 for Gigabit Ethernet interfaces only.
When listed in command line output, Gigabit Ethernet interfaces are
preceded by the characters Gi, Ten-Gigabit Ethernet interfaces are preceded
by Te, and Forty-Gigabit Ethernet interfaces are preceded by Fo, as shown in
the examples below.
Stacking Interfaces
Stacking interfaces are represented in the CLI with the same unit/slot/port
form as Ethernet interfaces. The fixed stacking interfaces on the
N2000/N2100-ON/N2200-ON/N3000-ON switches always use the
TwentyGigabitStacking or Tw notation and on the N1100-ON/N1500
switches, are referred to using Ethernet notation.
Interface Type Long Form Short
Form
Single
Character
Short
Form
Interface Identifier
Gigabit Ethernet Gigabitethernet G or
Gi
Y unit/slot/port
10-Gigabit
Ethernet
Tengigabitethernet Te Y unit/slot/port
21-Gigabit
Stacking
Twentygigabitstacking Tw n/a unit/slot/port
40-Gigabit
Ethernet
Fortygigabitethernet Fo Y unit/slot/port
Loopback Loopback Lo Y loopback-id (0-7)
Port Channel Port-channel Po Y port-channel-number
(1-128) N1500 (1–64)
Tunnel Tunnel Tu n/a tunnel-id (0-7)
Vlan VLAN Vl Y vlan-id (1-4093)