Users Guide

Layer 2 Switching Commands 613
The string configured by the hostname command is transmitted by the
system-name TLV.
If no TLV argument is given, the configuration remains unchanged.
Use the show lldp remote-device all command to see the advertised LLDP
neighbor information.
The management address TLV is type 8. The switch will send the address of
the service port, if available, otherwise, the IP address of the switch, if
defined, otherwise, the MAC address of the switch. The interface numbering
subtype sent is always IfIndex. If IPv6 management addresses are configured,
they are also sent.
See the lldp med command for additional LLDP transmission capabilities.
Command History
Syntax updated in version 6.5. Deprecated lldp transmit-tlv command in
favor of lldp tlv-select command in 6.5.2 firmware release. Deprecated lldp
transmit-mgmt command in favor of lldp tlv-select management-address in
6.5.2 firmware release.
Example
The following example shows how to include the system description TLV in
local data transmit.
console(config-if-Gi1/0/3)#lldp transmit-tlv system-description
show lldp
Use the show lldp command to display the current LLDP configuration
summary.
Syntax
show lldp
Default Configuration
This command has no default configuration.