Install Guide

5. Drill four 0.3 in (8 mm) holes in the wall at the pencil marks.
6. Install four wall-mount anchors into the four holes.
7. Screw four M5 screws into the four wall-mount anchors leaving approximately 0.20 in (5 mm) gap between the anchor and
the screw.
8. Slide the EPS onto the screws and tighten the screws to secure the EPS in place.
Torque the screws to 24 in-lbs.
Important information
The following is information that you need to safely use the EPS:
About Notes, Cautions, Warnings
NOTE: A NOTE indicates important information that helps you make better use of your product.
CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid
the problem.
WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
Installation
WARNING:
This equipment must be earthed. Connect the power plug to a properly wired earth ground socket
outlet.
N-Series EPS installation 9