Users Guide

1390 VRRP
Configuring VRRP Features (CLI)
This section provides information about the commands used for configuring
VRRP settings on the switch. For more information about the commands, see
the
Dell EMC Networking N1100-ON, N1500, N2000, N2100-ON, N2200-
ON, N3000E-ON, N3100-ON, and N3200-ON Series Switches CLI Reference
Guide
at www.dell.com/support.
Configuring VRRP Settings
Use the following commands to configure switch and interface VRRP
settings. This set of commands also describes how to configure VRRP
interface and route tracking.
Command Purpose
configure Enter global configuration mode.
ip vrrp Enable the administrative mode of VRRP for the router
(L3 switch).
interface vlan
vlan-id Enter Interface Configuration mode for the specified
VLAN.
vrrp
vr-id Allow the interface to create in the VRRP group specified
by the
vr-id parameter, which is a number from 1–255.
vrrp
vr-id description (Optional) Create a text description that identifies the
VRRP group.
vrrp
vr-id preempt [delay
seconds ]
Enable the preemption mode value for the virtual router
configured on a specified interface.
A preempt delay can optionally be configured. A preempt
delay is the number of seconds the VRRP router waits
before the VRRP router sends an advertisement to claim
primary ownership.
vrrp
vr-id accept-mode Allow the VRRP primary to accept ping packets sent to one
of the virtual router’s IP addresses.
vrrp
vr-id priority
priority
Set the priority value for the virtual router configured on
the interface.
vrrp
vr-id ip ip-address
[secondary]
Set the virtual router IP address value for an interface.