Users Guide

692 Port Characteristics
switchport trunk
{allowed vlan vlan-
list|native vlan vlan-id}
Set the list of allowed VLANs that can receive and send
traffic on this interface in tagged format when in trunking
mode.
• allowed vlan-list — Set the list of allowed VLANs that
can receive and send traffic on this interface in tagged
format when in trunking mode. Separate non-consecutive
VLAN IDs with a comma and no spaces. Use a hyphen to
designate a range of IDs.
The vlan-list format is all | [add | remove | except] vlan-
atom [vlan-atom...] where:
• all—Specifies all VLANs from 1 to 4093. This keyword
is not allowed on commands that do not permit all
VLANs in the list to be set at the same time.
• add—Adds the list of VLANs to the allowed set.
• remove—Removes the list of VLANs from the allowed
set. Removing the native VLAN from a trunk port
forces the port to allow tagged packets only.
• except—Allows all VLANs other than those in the list.
• vlan-atom —Either a single VLAN number from 1 to
4093 or a continuous range of VLANs described by two
VLAN numbers, the lesser one first, separated by a
hyphen.
• native vlan-id— The untagged VLAN. Untagged packets
received on this interface are switched in the native
VLAN. Transmitted packets in this VLAN are sent
untagged.
CTRL + Z Exit to Privileged Exec mode.
show interfaces
switchport interface
Display information about the VLAN settings configured
for the specified interface. The interface variable includes
the interface type and number.
Command Purpose