Administrator Guide

Audio Visual Bridging Commands 1112
MVRP propagates VLAN registration information to allow switches in the
network to dynamically learn and configure VLANs. Refer to IEEE Std.
802.1Q-2005 and IEEE Std. 802.1Qbe-2010 for further information. In
particular, MVRP must also be enabled on the individual interfaces to
become operational.
MVRP does not support configuration of default group filtering behavior.
MVRP does not support the optional Registrar Administrative Control for
VLANs.
If a VLAN is statically configured on an interface and MVRP requests
registration (dynamic creation) of the VLAN, it is deleted and added back as a
tagged static VLAN. If subsequently deleted by the operator, the VLAN is
dynamically created.
If a VLAN is configured as forbidden on an interface and MVRP requests
registration (dynamic creation) of the same VLAN, MVRP does not configure
the port association.
MVRP is only supported on trunk or general mode ports.
This command is only available on the N4000 Series switches.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example enables MVRP globally.
console(config)#mvrp global
mvrp periodic state machine
Use this command to globally enable the MVRP periodic state machine. Use
the no form of the command to globally disable the MVRP periodic state
machine.
Syntax
mvrp periodic state machine
no mvrp periodic state machine