Administrator Guide

Layer 3 Routing Commands 1324
Example
console(config-router-af)#neighbor 10.130.14.55 route-reflector-client
neighbor send-community (BGP Router
Configuration)
Use the neighbor send-community command to configure the local router to
send the BGP communities attribute in UPDATE messages to a specific
neighbor.
Syntax
neighbor ip-address send-community
no neighbor ip-address send-community
• ip-address – The neighbor’s IPv4 address.
Default Configuration
The communities attribute is not sent to neighbors by default.
Command Mode
BGP Router Configuration mode
User Guidelines
There are no user guidelines.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#neighbor 10.130.14.55 send-community