Administrator Guide

Layer 3 Routing Commands 1351
• ipv4-address | ipv6-address —(Optional) If a peer address is specified, the
output is limited to an individual peer.
• interface-id—(Optional) If the peer address is an IPv6 link local address,
the interface that defines the scope of the link local address must be given.
This must be a VLAN routing interface.
• autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration sub-
modes
User Guidelines
• “RFC 5549 Support” is displayed only if the BGP neighbor is peered over
IPv6 network.
• If the peer is configured as “autodetect”, the “Remote Address” shows
detected IPv6 address or “Unresolved” in case if the peer is not detected by
the autodetect feature.
• “Autodetect status” is displayed only if the peer is configured as
“autodetect”. The field shows one of the following statuses:
• Peer is detected
• Peer is not detected
• Multiple peers are detected
The following fields are displayed.
Field Description
Remote Address The neighbor’s IPv6 address. If this is a link local
address, the next line indicates the scope of the address.
Remote AS The neighbor’s autonomous system number
Peer ID The neighbor’s BGP router ID