Administrator Guide

Layer 3 Routing Commands 1352
Peer Admin Status START or STOP
Peer State The adjacency state of this neighbor
Peer Type The type of peer
Listen Range The ports that are being listened to.
Local Port TCP port number on the local end of the connection
Remote Port TCP port number on the remote end of the connection
Connection Retry Interval How long BGP waits between connection retries
Neighbor Capabilities Optional capabilities reported by the neighbor,
recognized and accepted by this router. Codes listed in
the show output are as follows:
• MP: Multiprotocol
• RF: Route Refresh
This version of Dell EMC Networking does not support
any multiprotocol AFI/SAFI pairs other than IPv4
unicast. The presence of this capability does not imply
otherwise.
IPv4 Unicast Support Indicates whether IPv4 unicast routes can be exchanged
with this peer. Both indicates that IPv4 is active locally
and the neighbor indicated support for IPv4 unicast in
its OPEN message. Sent indicates that IPv4 unicast is
active locally, but the neighbor did not include this
AFI/SAFI pair in its OPEN message. IPv4 unicast is
always enabled locally and cannot be disabled.
IPv6 Unicast Support Indicates whether IPv6 unicast routes can be exchanged
with this peer. Both and Sent have the same meaning as
for IPv4. None indicates that neither the local router
nor the peer has IPv6 enabled for this adjacency.
Received indicates that the peer advertised the IPv6
unicast capability, but it is not enabled locally. IPv6
unicast is enabled locally using the neighbor activate
command in address-family IPv6 configuration mode.
RFC 5549 Support If support for RFC 5549 is enabled.
Update Source The configured value for the source IP address of
packets sent to this peer. This field is only included in
the output if the update source is configured.