Administrator Guide

Layer 3 Routing Commands 1364
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console#show bgp ipv6 summary
IPv6 Routing .................................. Enable
BGP Admin Mode ................................ Enable
BGP Router ID ................................. 1.1.1.1
Local AS Number ............................... 65001
Traps ......................................... Disable
Maximum Paths ................................. 1
Maximum Paths iBGP ............................ 1
Default Keep Alive Time ....................... 30
Source A source of routes that BGP is configured to
redistribute.
Metric The metric configured with the redistribute command.
Match Value For routes redistributed from OSPF, the types of OSPF
routes being redistributed.
Distribute List The name of the prefix list used to filter redistributed
routes, if one is configured with the distribute-list out
command.
Route Map The name of the route map used to filter redistributed
routes.
Neighbor The IP address of a neighbor
ASN The neighbor’s ASN
MsgRcvd The number of BGP messages received from this
neighbor
MsgSent The number of BGP messages sent to this neighbor
State The adjacency state. One of IDLE, CONNECT,
ACTIVE, OPEN SENT, OPEN CNFRM, EST
Up/Down Time How long the adjacency has been in the
ESTABLISHED state, or, if the adjacency is down, how
long it has been down. In days:hours:minutes:seconds
Pfx Rcvd The number of IPv6 prefixes received from the neighbor