Administrator Guide

Layer 3 Routing Commands 1576
Example
console#show ipv6 mld host-proxy groups
Interface................................ vlan 10
Group Address Last Reporter Up Time Member State Filter Mode Sources
------------- -------------- ---------- ----------------- ------------ -----
--
FF1E::1 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 2
FF1E::2 FE80::100:2.3 00:02:40 DELAY_MEMBER Include 1
FF1E::3 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 0
FF1E::4 FE80::100:2.3 00:02:44 DELAY_MEMBER Include 4
show ipv6 mld host-proxy groups detail
Use the show ipv6 mld host-proxy groups detail command to display
information about multicast groups that MLD Proxy reported.
Syntax
show ipv6 mld host-proxy groups detail
Default Configuration
There is no default configuration for this command.
Group Address The IP address of the multicast group.
Last Reporter The IP address of the host that last sent a membership report for the
current group on the network attached to the MLD-Proxy interface
(upstream interface).
Up Time (in
secs)
The time elapsed in seconds since last created.
Member State Possible values are:
• Idle_Member — The interface has responded to the latest group
membership query for this group.
• Delay_Member — The interface is going to send a group
membership report to respond to a group membership query for
this group.
Filter Mode Possible values are Include or Exclude.
Sources The number of sources attached to the multicast group.